How to paint the car interior
You can tune in any way from sporting rate Rally
To paint on plastic one must first remove impurities, either rest or silicone waxes which may be in the same, this step is the most important, but since then rose painting, for it must be cleaned well with a rag with thinner, the ideal is that you can remove the plastic and paint to handle it better, either board, air vents, handles external mirrors, etc.,…
How to paint the car interior. Manual tuning also say to sand with sandpaper plastic water (No 320 or 280, more or less), then apply a single hand of an adhesion promoter for plastics (a fixative), leave approximately 15 minutes and apply a Prime (a fund), the ideal is to be of two components, or with a catalyst (dilution of 4 to 1), you can also employ a single component (less expensive), in both cases not much solvent, you have 2 to 3 hands, with intervals of 10 minutes, you say that the ideal is that of 2 components because it pays more and more body, leave 2 or 3 hours and lijas with sandpaper water No 320 using a taquito chiquito rubber, thus remove every pore evoke plastics because of his, if you see that there are still some lijas and pores, we revert to give 1 or 2 hands over Prime.
Remember that you must always be careful not to be wet paint to the piece, or with remnants of dirty water, as it rose painting over time. And what would you be ready to paint, the color will depend on you, if you want another color of your car, you will have a code inside the engine or doors, and certainly will bilayer, commissioned to prepare a little painting, (you prepared in 1 / 4 minimum), and you have 2 or 3 hands, leave 10 minutes (without touching), and 2 hands apply lacquer or varnish bilayer (for a spectacular ending, uses the veneer of 2 components also, called polyurethane varnish, you do not need polishing. If you want another color for the interior can use you like.
You can also use an acrylic, less expensive and would then apply varnish that can be a single component, and what polish.
Remember you have to maintain an ambient temperature, more or less than 20 degrees, and use thinner good, golden seal, or special, to give greater brightness.